PP319FTCRED - Circuit Tester Kits

Introduction

The Power Probe 3 is a Digital Voltmeter designed to work on 12-24 Volt sources, with the ability to apply Power and Ground. Using an Auxiliary Ground cable, the user can simultaneously supply Battery Voltage, and ground to test components or to simply test for continuity. The PP3 is protected by an 8 Amp Circuit Breaker.

Features

- Voltage & Polarity testing

- Continuity testing

- Activating components out of the vehicle’s electrical system

- Activating electrical components in the Vehicle

- Activating electrical components with ground

- Testing trailer lights and connections

- Checking for bad ground contacts

- Red/Green Indicator & Audio Tone

Specifications

- DC 0 – 70V + 1 digit

- P-P 0 – 70V

Frequency response of tone pass through

- 10Hz to greater than 10 Khz

PP display

- 15Hz Square Wave

- 35Hz Sine Wave

Power Probe Mode – Continuity to ground

- First level – display is enabled less than 20K

- Second level – green LED is enabled less than 2K

– & + Peak Detector Response

- Single event capture less than 200μs pulse width

- Repetitive events less than 1μs pulse width

Peak to Peak Mode

- 0 – 70V + 1 digit

- 4Hz to over 500kHz Square Wave input

- 4Hz to over 250kHz Sine Wave input

Threshold for PPAC/Audible passthrough

Circuit Breaker

8 amp thermal response – Manual reset

Typical Response